Galvanized

The modular structure is traditionally used for high performance shielding. Panels are galvanized sheet steel bonded to a wood core that are attached via framing joints. The RF panel system is typically supported via threaded rod and dielectric isolators attached to the deck above or can be self-supported using C-joists. The RF galvanized flooring system consists of galvanized steel panels installed over a 6 mil vapor barrier and layers on Masonite (used as an isolator and filler between the framing channels). The top of the RF panel is then filled with VCT leveling tiles flushing the floor with the profile of the framing channels; providing a sub-surface ready to accept finish flooring by others.

1/32" to 1/8" Lead Wall

Lead roll shielding is typically utilized for imaging modalities such as Computed Tomography (CT), Ultrasound, and X-Ray.

---

1/4" to 3/4" Lead Wall

Lead panel shielding is typically used for Positron Emission Tomography (PET) suites.

---

1" and up Lead Wall

Lead brick shielding is typically used for Positron Emission Tomography (PET) suites and linear accelerator (LINAC) vaults.

Radiation Therapy Sliding Door

Our Radiation Therapy Sliding Door is a state-of-the-art electric operating system and top mounted linear motion system for ease of opening and closing. These doors are made up from lead & concrete ranging anywhere from 1,000 lbs to 30,000 lbs. There is a battery backup system and emergency disconnect features.

---

Radiation Therapy Swing Doors

Our Radiation Therapy Swing Doors are designed to withstand all loads without deflection that might inhibit operation or impair radiation protection. Doors are equipped with a Brookfield operating system which is fully compliant with UL 325 and ANSI 156.10 for swing doors weighing up to 20,000 lbs. Doors are mounted to the frame with (2) Two HD Brookfield hinges. All of our doors are supplied with a primer coat for finish by others.

AC ELF Magnetic Shielding is typically comprised of fully welded 1/4” aluminum plates. Aluminum is fastened to 3/4” plywood substrate. All seams, joints, corners, and butts are fully welded to ensure electrical conductivity. In some instances Low Carbon Steel is added to the design.

This Electromagnetic shielded enclosure prevents interference of the equipment within the room caused by power, data, telephone lines, or metallic paths. The shielded enclosure ensures the equipment will perform to its full potential.

SCIF Shielding is typically comprised of a conductive aluminum radiant barrier. Material is made up of a single layer of woven polyethylene material bonded and sandwiched between two highly reflective aluminum surfaces. This aluminum foil material is specifically designed to be used in SCIF applications. Shielding is adhered to existing concrete/gypsum surfaces using construction adhesive or staples. All seams are overlapped 6” and taped using 3” wide conductive aluminum tape.

Partial Discharge

Partial Discharge (PD) Shielding are typically comprised of conductive galvanized panels at the walls and ceiling with a copper mesh ground plane at the floor. The host building is typically electrically isolated from the Faraday cage. This product is typically used in High Voltage (HV) laboratories to shield against air borne and ground borne electrical noise.

Prefabricated modular lead shielded enclosures consist of free standing structural steel framed panels and one or more doors with optional control windows. Sections consist of steel-lead-steel panels fabricated with the required thickness of sheet lead. All edges are covered by steel. All modular panels incorporate lead joint strips.